1. Makisupa79's Avatar
    I have the correct ISPW and redsn0w for my 3gs running 3.0.1

    I fired up redsn0w, gave it the ISPW and followed the instructions to put it in recovery mode and re-attached it to the usb cord.

    When I plugged it in, I got a "new device drivers found" and something about iphone recovery mode message from vista. I watched multiple Youtube videos showing how to jailbreak, and didn't see this pop up once.

    My vista options were install drivers, ask me later, or never ask again...I chose ask me later.

    Anyway, now redsn0w is not advancing the jailbreak and the recovery mode instructiosn page is still up. My phone still shows the usb/itunes logo and nothing is happening. Been sitting this way for 10 minutes. Don't know what to do.

    Should I detach my phone, reattach it and allow vista to install the device drivers? I'm at a loss for what to do here.

    I don't want to do anythign that will force me to have to do a full recovery through itunes and be stuck with 3.1, so what are my options?
    09-15-2009 01:33 PM
  2. Makisupa79's Avatar
    Well, after sitting in recovery mode for 10-15 mins, my phone just restarted, and appears to be fine. The jailbreak was unsuccessful, but I am still running 3.0.1 and the tethering hack is still available.

    So what should I do next time I try jailbreaking and this vista/new device driver option comes up?
    09-15-2009 01:40 PM
  3. Makisupa79's Avatar
    And, more importantly, I guess I should ask in case I try jailbreaking again and run into the same error...what is the proper way to take it iphone out of recovery mode without doing a restore?
    09-15-2009 02:09 PM
  4. Makisupa79's Avatar
    Grrr....I just googled this, and the first google hit was this thread. I know I can't be the only one with this New Device Drivers error found when connecting the iphone in recovery mode to a Vista machine. Help?
    09-16-2009 12:41 PM
  5. Makisupa79's Avatar
    I doubt it has anything to do with it, but I did enable tethering w/o jailbreaking my iphone last week by following the instructions on this site

    mydigitallife.info/2009/06/28/activate-and-enable-iphone-as-internet-tethering-wireless-modem-without-hack-or-jailbreak/

    obviously the above link starts with (http : //www .) but I cant post links yet.
    09-16-2009 01:41 PM
  6. Makisupa79's Avatar
    Also, FWIW, I tried again today, and encountered the same problems described in my first post...as soon as I attached in DFU mode, I got the Vista message, hit "ask me later", redsn0w would not advance, and after 10-15 mins, my iphone rebooted and was running normal and still in 3.0.1 and not jailbroken.
    09-16-2009 02:09 PM
  7. Makisupa79's Avatar
    Also, Don't know if it matters but mymodem Firmware is 04.26.08
    09-16-2009 11:35 PM
  8. Makisupa79's Avatar
    I am going to get my post count up with a couple bumps, and post the screen shot of the exact vista message I get next time I try jailbreaking if I don't get an answer in a day or two. Maybe that will help if I am not describing the message well enough.
    09-16-2009 11:38 PM
  9. jglowe74's Avatar
    this is weird.

    i have Vista and iPhone 3GS also. when trying to JB with redsn0w i was put in DFU mode several times before i got it right. never once did my PC say anything about these device drivers needing to be installed. but i didn't have the tethering hack installed on my iPhone either. could this be the source of the problem?

    since the PC is wanting you to install new device drivers, i'm wondering if it's not because the USB is needing updated to support the tethering? wonder what the harm could be in installing these drivers on your PC. i wouldn't think it would effect the iPhone any.

    anyway, what i ended up doing to JB was connect my iPhone to USB and had iPhone powered on. launched redsn0w, pointed to my IPSW file for 3GS running 3.0.1. this worked fine. i'm still JB!

    what i did PRIOR to this was i had iPhone powered off THEN connected to USB. that kept putting me back in DFU mode over, and over, and over...

    good luck. let us know how this turns out.
    09-17-2009 07:24 AM
  10. jglowe74's Avatar
    this is from a different thread discussion and how i got my solution:

    HI-OH! i finally got it to work. installed successfully and Cydia is present. hallelujah!

    i followed some instructions on this forum that said to make sure the phone is powered off the and connected to USB. i would then enter DFU mode by holding power, then power & home keys, then home key by itself. that's when redsn0w would crash on me.

    well, i kept iPhone ON this time and connected to USB. THEN launched redsn0w. it gave me a different set of instructions to disconnect then power off, then hold home key and reconnect, THEN launch redsn0w. it took off right away installing the hack. such an easy thing that i made into a difficult thing. but the directions are misleading on the original post. unless i'm reading them wrong. http://www.theiphoneblog.com/2009/06...dsn0w-edition/
    09-17-2009 07:30 AM
  11. Makisupa79's Avatar
    Thanks jg- I don't know if it's the tethering or not, but I'm hesitant to install them because I'm afraid with the phone in reco ery mode, whatever these drivers are might kick me to iTunes and force me to restore to 3.1

    if I don't find an answer soon, I think I may just try this on my parents XP CPU next time I visit them. If that fails then maybe it is the tethering.

    Thanks for the advice, but I was actual aware of when to have it on due to one of your older posts. Can't remember the OPs name, but you did a good job of explaining the redsn0w process, so thanks!
    09-17-2009 07:43 AM
  12. jglowe74's Avatar
    Sure thing. I didn't even think about iTunes possibly forcing you into updating to 3.1. Good luck!
    09-17-2009 12:12 PM
  13. Makisupa79's Avatar
    Thanks. Thinkim going to give up on vista and try on xp. I have posted this on 3 message boards but can't find an answer. If I do find one I will report back for future users with the same problem.
    09-17-2009 03:01 PM
  14. Makisupa79's Avatar
    Ok, tried uninstalling and re-downloading iTunes...someone on another forum thought that would help. Cross your fingers, here goes try 3...if this doesn't work, I'm holding out for the XP machine.
    09-17-2009 10:02 PM
  15. Makisupa79's Avatar
    Well, we are now 0-3 in the Makisupa79 Vs. Vista Jailbreak Bonanza folks.

    Same results as the last two attempts (at least I hope so)...waiting for the iPhone to reboot and leave recovery mode like it did the last two times.
    09-17-2009 10:15 PM
  16. Makisupa79's Avatar
    Just for the heck of it, I tried a fourth time. I heard Icy gave some 3gs's problems earlier in the summer, so I tried just installing cydia instead of both...still no luck. But I managed to snag a screencap of the error message, doubt it will help, but you never know.

    http://img10.imageshack.us/img10/464...eaktrouble.jpg
    09-17-2009 10:34 PM
  17. Makisupa79's Avatar
    Success!!! Although not over Vista. I gave up, tried it on an XP machine, and I jailbroke my 3GS on the first try. So in the future, if anyone finds this thread by searching, if Vista is giving you problems, just beg borrow or steal a new CPU running XP.
    09-18-2009 04:43 AM
  18. jglowe74's Avatar
    Success!!! Although not over Vista. I gave up, tried it on an XP machine, and I jailbroke my 3GS on the first try. So in the future, if anyone finds this thread by searching, if Vista is giving you problems, just beg borrow or steal a new CPU running XP.
    awesome! i too, almost gave up on my vista machine. but eventually it let me JB. and i've never looked back since. 3.1? not me, not yet. i'll wait for the DevTeam to update before i even consider updating my OS to 3.1.

    enjoy
    09-18-2009 08:12 AM
  19. DaPeeps's Avatar
    wow...that is strange. I've jailbroken 3GS's on Vista and Windows 7, and never had an issue. The only problem I had was when I tried jailbreaking a 3GS with Redsnow 0.7...it would not work until I used 0.8
    09-19-2009 08:27 AM
LINK TO POST COPIED TO CLIPBOARD