1. bzowk's Avatar
    Good Afternoon -

    This afternoon, I started replacing my iPad 3's glass screen and bezel again as the 1st replacement screen didn't work 100%. I am also replacing the black plastic bezel which goes around it as well as the home button assembly which never worked correctly.

    I got everything disassembled, swapped the parts, and put it back together (sans adhesive) and it all worked perfectly for once! There's just one issue I can't resolve...

    The glass / bezel / aluminum body is a snug fit! Evedentually over the past few months, the aluminum must have become not as square is it was from the factory. When I put my glass in, it doesn't fit correctly and is very difficult to do with replacing the bezel at the same time.

    I tried tacking down the bezel to the aluminum body with a few drops of super glue. This made it easier, but still didn't fit. If the glass were stronger, I'm sure I could pop it in, but it's obviously very fragile (and expensive!)

    Any suggestions? Thanks!
    11-21-2012 04:36 PM

Similar Threads

  1. Trying to replace Filofax with iPad
    By caribmilly in forum iPad Series
    Replies: 6
    Last Post: 11-24-2012, 08:22 AM
  2. North Sydney Restaurant Replaces Menus with iPads
    By Lotus Esprit V8 in forum iPad Series
    Replies: 3
    Last Post: 06-10-2010, 09:38 AM
  3. Replies: 4
    Last Post: 05-19-2010, 06:31 AM
  4. Trouble using iPad with Projector
    By Watkinsd in forum iPad Series
    Replies: 3
    Last Post: 04-16-2010, 10:17 PM
  5. Problem with my screen?
    By cjvitek in forum iPhone 4
    Replies: 12
    Last Post: 07-15-2008, 10:10 PM