Normally, I hate screen protectors due to them being blatantly obvious, edges showing distortion/reflections to make them stick out worse, edges can be felt when swiping, edges collect LOTS of dust. With the screen replacement cost of the X being double that of the past, I decided not to risk a bare screen with this one. I tried a Tozo 3D which blatantly screamed that there was a screen protector on there. Then I tried an Anker Karapax which only covered the OLED section. The Anker felt pretty smooth, but had all of the downsides of a typical screen protector in appearance. Finally, I found this i-Blason and it's pretty much like the actual iPhone X screen being bare. The edges wrap around slightly, super smooth feel when swiping, I actually don't feel any edges at all swiping from the bottom and my Apple Leather case wraps around the sides perfect with a little lip protection left. The all clear glass covers the sensor notch areas except for the speaker opening, so I've not had to wipe dust or anything from that area, and I don't have a black notch on the screen protector trying to line up with the phone's notch. It's all clear and seamless glass around the edge bezels. Like the manufacturer states, and many can confirm including myself, any air bubbles left after install (if a completely clean screen free of dust was prepared first) will go away on their own within 24 hours. For the quality of this, and end results, I would happily pay way more than what it costs. I got mine for $8.39. Installed product looks identical to the renderings.
https://www.amazon.com/i-Blason-iPh...ag=hawk-future-20&ascsubtag=UUimUvbUpU3014465View attachment 120411