1. dave macbook pro's Avatar
    Mid 2012 MBP (Retina) stopped charging after weeks of Magsafe 2 acting weird (PLEASE HELP)

    Very frustrated after days looking for a solution online, hope this forum can help me out...

    So almost a month ago, the magsafe 2 light on my mid 2012 MBP (retina) starting acting weird, switching from amber to green light for no reason ... that was all the issue in the beginning. It wasn't really affecting anything... except some random restarts from time to time.

    But, last week my computer starting to run out of battery fast and shutting off while it was still plugged in!

    It mainly started happening every time I started rendering videos, which I know it uses a lot of resources and electricity.

    I tried resetting SMC many times (Shift+Control+Option keys and the Power button at the same time, waited 5 to 10 seconds and let go). I did see the light change from amber to green after releasing the keys. Of course after a few minutes started to act up again and switching from green to amber.

    So, little by little this started to happen more and more often until my computer would no longer charge while it was in use. It would ONLY charge if the computer was shut off. Let me remind you that it was still switching from green to amber light for no reason. However, I noticed that it was staying "mostly" amber while charging .. and then stayed "mostly" green while the battery reached 100% charge. At this point it was taking 8 to 9 hours to fully charge the battery while the computer was shut downed.

    Well, a few days ago, it stopped charging completely! Not even when the computer is off. Also, no light was coming out at all, of any color. I tried resetting the SMC again, with no response at all!

    Now all I get when I plugged the magsafe cord in, is static noises inside the computer (very low volume noises that kind of sounds like electricity maybe? very hard to hear unless you get your ear right next to the keyboard). I still have 70% battery left on my MBP since the last time I was able to charge it a few days ago (I'm being very careful and use it only when I need to). The computer seems to be working fine without the cord, and "seems" to be holding charge "normally". The computer itself seems to be working normally.

    I just order a new cord, but I really have no idea what the problem could be. Specially since I'm getting weird noises when I plugged the cord into my laptop.

    Any help or suggestions is greatly appreciated. I work at home (freelancer) so I'm kind of stuck now and it is hurting my business. Very stressful situation.

    This is my latest power report I got from my laptop a few minutes ago... (cord unplugged since I don't know if it is actually hurting my computer by plugging it in)...

    Battery Information:

    Model Information:
    Serial Number: D86235537FUDNMGA9
    Manufacturer: SMP
    Device Name: bq20z451
    Pack Lot Code: 0
    PCB Lot Code: 0
    Firmware Version: 511
    Hardware Revision: 000a
    Cell Revision: 1150
    Charge Information:
    Charge Remaining (mAh): 4963
    Fully Charged: No
    Charging: No
    Full Charge Capacity (mAh): 7245
    Health Information:
    Cycle Count: 346
    Condition: Normal
    Battery Installed: Yes
    Amperage (mA): -1647
    Voltage (mV): 11339

    System Power Settings:

    AC Power:
    System Sleep Timer (Minutes): 10
    Disk Sleep Timer (Minutes): 10
    Display Sleep Timer (Minutes): 10
    Wake on AC Change: No
    Wake on Clamshell Open: Yes
    Wake on LAN: Yes
    AutoPowerOff Delay: 14400
    AutoPowerOff Enabled: 1
    DarkWakeBackgroundTasks: 1
    Display Sleep Uses Dim: Yes
    GPUSwitch: 2
    Hibernate Mode: 3
    PrioritizeNetworkReachabilityOverSleep: 0
    Standby Delay: 4200
    Standby Enabled: 1
    Battery Power:
    System Sleep Timer (Minutes): 60
    Disk Sleep Timer (Minutes): 10
    Display Sleep Timer (Minutes): 15
    Wake on AC Change: No
    Wake on Clamshell Open: Yes
    AutoPowerOff Delay: 14400
    AutoPowerOff Enabled: 1
    Current Power Source: Yes
    DarkWakeBackgroundTasks: 0
    Display Sleep Uses Dim: Yes
    GPUSwitch: 2
    Hibernate Mode: 3
    Reduce Brightness: Yes
    Standby Delay: 4200
    Standby Enabled: 1

    Hardware Configuration:

    UPS Installed: No

    AC Charger Information:

    Connected: No
    Charging: No

    THANK YOU SO MUCH FOR YOUR TIME AND HELP!
    02-02-2019 01:56 PM
  2. Just_Me_D's Avatar
    If I had to guess, I’d say you need to replace both the battery and the charging cable. To be certain, I’d make a Genius Bar appointment with the nearest Apple Store to have them diagnose the problem for you.
    02-02-2019 02:01 PM
  3. cornettbr's Avatar
    Google the power switching board, also replace the battery and potentially the MagSafe board. If it’s the power switching board and you are not solid with soldering you could be looking at a 2-400 logic board replacement “if” you do it yourself.
    03-06-2019 04:51 PM

Similar Threads

  1. Find out how long the Fitbit Charge 3 battery last!
    By iMore.com in forum iMore.com News Discussion
    Replies: 0
    Last Post: 02-02-2019, 08:12 AM
  2. Do existing Fitbit chargers work on the Charge 3?
    By iMore.com in forum iMore.com News Discussion
    Replies: 0
    Last Post: 02-02-2019, 07:12 AM
  3. Help! I need to reset my clock on my iPhone
    By iMore Question in forum Ask a Question
    Replies: 1
    Last Post: 02-02-2019, 05:55 AM
  4. Does Fitbit Charge 3 track yoga?
    By iMore.com in forum iMore.com News Discussion
    Replies: 0
    Last Post: 02-01-2019, 05:51 PM
  5. Track your 2019 activities in style with $31 off Fitbit's new Charge 3
    By iMore.com in forum iMore.com News Discussion
    Replies: 0
    Last Post: 02-01-2019, 06:40 AM
LINK TO POST COPIED TO CLIPBOARD