1. eabhvee's Avatar
    My MacBook Pro (mid 2010) battery died a couple of weeks ago. I was planning to give it away, so wiped the hard disk and tried to re-install the os (without a battery). Could not complete the process as MBP would shut down as soon as installation starts. I replaced the battery, since then it fails to boot into recovery. It freezes halfway into the boot. I tried the following options

    Tried to boot from USB
    Reset SMC
    Reset PRAM + NVRAM
    Internet recovery : fails with 3403F message
    Run health check, also internet health check : failed
    Verbose mode: freezes after this message "NVDANV50HAL loaded and registered"
    Safemode : failed


    Any help out there?
    01-07-2018 12:16 AM
  2. Quis89's Avatar
    Do you have an external bootable hard drive you could try booting from? Might you have another Macbook? If so, you could pull the hard drive from the 2010 model and connect it externally to your other Macbook, then you could run disk utility and attempt a repair.
    01-08-2018 10:41 AM

Similar Threads

  1. Is wireless charging bad for batteries?
    By linear2202 in forum iPhone 8
    Replies: 15
    Last Post: 01-16-2018, 12:08 AM
  2. Replies: 56
    Last Post: 01-14-2018, 07:43 PM
  3. Replies: 5
    Last Post: 01-07-2018, 03:05 AM
  4. Replies: 3
    Last Post: 01-06-2018, 08:32 PM
  5. Replies: 6
    Last Post: 01-06-2018, 02:43 PM
LINK TO POST COPIED TO CLIPBOARD