Hello
I managed to replace the screen on my iPhone 7 this morning.
It wasn't too difficult, other than getting the old screen to release from the case in first place … lots of heat and a big suction cup finally managed to get it going.
Everything now back together and phone works fine … however :-
Please see photo of the 2 small rubber washers that are 'spare' … they fell out of somewhere while I was removing the old screen.
I looked all over but couldn't see anywhere where they were supposed to go.
I hope the were off the old screen and the new screen already had them fitted, so I won't need to remove the newly fitted screen.
They are rubber and approx. 2mm square and about 1.5mm thick.
Any guidance much appreciated.
I managed to replace the screen on my iPhone 7 this morning.
It wasn't too difficult, other than getting the old screen to release from the case in first place … lots of heat and a big suction cup finally managed to get it going.
Everything now back together and phone works fine … however :-
Please see photo of the 2 small rubber washers that are 'spare' … they fell out of somewhere while I was removing the old screen.
I looked all over but couldn't see anywhere where they were supposed to go.
I hope the were off the old screen and the new screen already had them fitted, so I won't need to remove the newly fitted screen.
They are rubber and approx. 2mm square and about 1.5mm thick.
Any guidance much appreciated.