Originally Posted by
Highrisedrifter OK, tried a couple of times to install it today and I get an error. I think I need a new cable as I get Error 4005, which apparently may happen if the device unexpectedly disconnects during the update or restore, or iTunes couldn't tell the device to go to the restore state.
I'll try again once I have a new cable. As this is my daily driver, I might hold off for the time being anyway. I'll just work on my apps on the iPad instead. As an old C++ programmer, it's hard getting back into the swing of things as so much has changed in the twenty years since I last did any meaningful programming.
Did you try it on all the different USB ports too? I've found that sometimes that might make a difference. I know there are 1.0, 2.0, 3.0 and depending, that could interfere maybe? Just sharing this as when I'd go to run an autoloader on my BB Z10, I had to plug it into one certain port or it would fail.
Sent from a larger than life device using Tapatalk!