1. jrpierce's Avatar
    I have this case:
    Slider Case for iPhone 3GS and iPhone 3G : Incase Product

    I actually love the case, but I just can't get it off. I like to switch it up every once and a while with my cases, and with all the new ones that came out with the 3GS I want to get a new one.

    Has anyone else had this happen?
    What did you do yo fix it?

    Thank You,
    Jake
    10-29-2009 10:46 PM
  2. big9erfan's Avatar
    They can be a little tight, I work my fingernails into the groove between the two pieces and start to pry them apart gently. Eventually it all works out.
    10-29-2009 10:56 PM
  3. jrpierce's Avatar
    No I can get the little part off no problem. The big part won't budge though.
    10-30-2009 12:28 AM
  4. big9erfan's Avatar
    Humm, ok I don't have that problem. Have you applied a full body cover like the ZAGG Invisible Shield or something similar?
    10-30-2009 12:31 AM
  5. jrpierce's Avatar
    Yeah I have the invisible shield on the front, but not the full phone one.
    10-31-2009 12:27 AM
  6. jhamilton3's Avatar
    I've only had this problem once.. I make sure to wipe the inside of the cases off after and before use.. seems to help sliding them on.
    10-31-2009 04:51 PM
  7. Levyesq#IM's Avatar
    I learned the trick from an Apple Store employee - Put your fingers over the bottom (short) piece with the base of your thumb (palm) on the (off) screen, and your other hand holding the edges of the longer piece. Pull. Counter-intuitive, you want to grab the edges of both pieces, but works every time.
    Last edited by Levyesq; 11-01-2009 at 06:01 PM.
    11-01-2009 01:59 AM
  8. zigzagg's Avatar
    I had the same issue. You need to move the silent switch to on position and try again
    11-01-2009 03:46 PM
LINK TO POST COPIED TO CLIPBOARD